Racking - Interlock Shelves

Metalware's Interlok No-Bolt design is based on three guiding principles:

Étagère type Interlock
  1. Strength: The ultimate in strength and rigidity has been obtained by the wedge-type combination of shelf and brackets.
  2. Economy: Assembly cost is a vital factor. Interlok No-Bolt eliminates obsolete methods of assembly. The amounts of nuts, bolts and tools have been reduced from the equation, saving up to 80% of assembly time.
  3. Efficiency: Shelves can easily be rearranged without dismantling. Interlok No-Bolt is assembled in an upright position. There is no additional floor space needed for the process of assembly.

Among the most rigid in the industry, Metalware shelving is produced in 18-gauge cold-rolled steel. Shelves are made of double-bends on all four sides, complete with closed corners. The uprights are made of 16-gauge hot-rolled steel and are pre-punched, roll-formed, welded and cut to length in a continuous operation.

Interlok No-Bolt steel shelves are designed for maximum strength and durability. A superior quality shelf has been obtained by combining these exclusive features:

Double folded closed corners for maximum support. A two-way locking principle at each corner. 1 3/16" flange on four sides plus a substantial return bend. For heavier loads reinforcing bars are added to the front and rear of the shelf. All shelves are punched for bin dividers.


Étagères - cabinets

No-Bolt assembly.

Metalware's No-Bolt Interlok steel shelving is a snap to assemble.

  1. Installing a shelf clip on a "T" upright (one-way locking) - Take a shelf clip and hold the longer end up. Insert the longer end first on the "T" upright at the desired slot height. Place the shorter bottom end in the slot directly below.
  2. Installing 2 shelf clips on a "T" upright (two-way locking for placing an add-on unit) - Place shelf clip in the opposite direction (as in the previous step) in the same slot.
  3. Installing a shelf - Place 1 shelf clip (as in step 1) at the desired height on all 4 "T" uprights. Place a shelf so that each corner slides over a shelf clip. Press the shelf down firmly to allow it to lock in between shelf clips and "T" uprights.
  4. Installation of Side Brace - Bolt side brace in an "X" style halfway up the "T" upright.
  5. Installation of Back Brace - Adjust angle of back brace to appropriate angle and bolt halfway up the reverse side of the shelving unit.
Capacité de 440 lbs

Load capacity 440 lbs

Now available: Storage drawer for Interlok shelves!

Project - December 2014

Serving you since 1987.
Accueil Useful Links Contact Us New Lift Trucks Used Lift Trucks Traction+ Racking & Shelving Services Products Batteries and Chargers Top Français